 |
|||
|
|
|||
|
Page Title:
VERTICAL LEVELING WORM GEAR AND HOUSING REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT (TRUCK M764) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-2
FRAME 5
Finger tighten adjusting bearing (1) against gear shaft (2).
1.
CAUTION
Be sure end of key clears thrust washer. It must not stop
worm adjusting bearing. Damage to equipment may result
if needed clearance is not set up.
Check clearance of key by turning shaft (2) by hand. Shaft must turn freely.
2.
Put bearing sleeve (3) on shaft (2). Push bearing sleeve down until slot on
3.
outside of bearing sleeve alines with hole for rear capscrew (4).
Put two capscrews (4) with lockwashers (5) and lockscrews (6) into housing (7),
4.
b u t do not tighten lockscrews.
5. Put in two lubrication fittings (8).
END OF TASK
17-626
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version