INTERMEDIATE CASE AND GEAR ASSEMBLY REMOVAL, REPAIR, REPLACEMENT AND ADJUSTMENT (TRUCK M764) - continued

TM 9-2320-209-34-2-2

FRAME 4

Remove intermediate gear assembly. Refer to para 17-47a and para 17-47b.

2. Disassemble feed gear and hub assembly. Refer to para 17-47c.

3. If reading in step 4 of frame 3 is less than 0.006 inch, do the following:

a. Take 0.006 inch thickness from feed gear shim set (1).

b. Add 0.006 inch thickness to drive and feed gear shim set (2).

4. If reading in step 4 of frame 3 is more than 0.024 inch, do the following:

a. Add 0.018 inch thickness to feed gear shim set (1).

b. Take 0.018 inch thickness from drive and feed gear shim set (2).

5. Assemble intermediate gear assembly. Refer to para 17-47 g.

6. Replace intermediate gear assembly. Refer to para 17-47h.

7. Do frame 1 again.

END OF TASK

17-553