|
|
TM 9-2320-209-34-2-2
c. Cleaning. There are no special cleaning procedures needed. Refer to
cleaning procedures given in Part 1, para 1-3.
NOTE
Clean all parts before inspection and before assembly.
d.
Inspection and Repair.
FRAME 1
1.
Check that pin (1) is not bent, cracked or worn.
2.
Check that mounting bracket (2), supporting bracket (3), three nuts (4),
bracket (5), housing (6) or stop arm (7) have no bends, dents, cracks or
damaged threading.
3.
Check that ball (8) is not worn or cracked.
4.
Check that spring (9) is not broken or distorted.
If any part is damaged, get a new part.
5.
END OF TASK
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |