|
|
TM 9-2320-209-34-2-1
14
STEERING
SYSTEM
GROUP
MAINTENANCE
Section I. SCOPE
procedures for the mechanical steering gear assembly for which there are authorized
corrective maintenance tasks at the direct and general support maintenance levels.
maintenance is authorized at the direct and general support maintenance levels are
covered in this chapter.
Section II. MECHANICAL STEERING GEAR ASSEMBLY
TOOLS : Bushing remover/replacer, pn 7083248
Sleeve bearing hand burnisher, pn 7083238
SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Tags
Plastic tiedown strap
Tape
Artillery and automotive grease, type GAA, MIL-G-10924
Lubricating oil, ICE, OE /HDO 10, MIL-L-2104
Housing side cover gasket
Cup, ball, and ring kit
Jacket-to-housing shim kit
PERSONNEL : One
EQUIPMENT CONDITION : Truck parked, engine off, handbrake set.
a. Preliminary Procedures.
(1) Remove pitman arm. Refer to TM 9-2320-209-20.
(2) Remove steering wheel. Refer to TM 9-2320-209-20.
(3) Remove air cleaner indicator. Refer to TM 9-2320-209-20.
(4) Open hood. Refer to TM 9-2320-209-10.
(5) Disconnect battery ground. Refer to TM 9-2320-209-20.
(6) Remove radiator and fan. Refer to TM 9-2320-209-20.
(7) Remove turn signal control. Refer to TM 9-2320-209-20.
(8) Remove engine rear lifting bracket. Refer to TM 9-2815-210-34.
(9) Remove throttle control and linkage. Refer to TM 9-2320-209-20.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |