 |
|||
|
|
|||
|
Page Title:
Removal of Bearing from Shaft by Pulling. |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-1
b.
Removal of Bearing from Shaft by Pulling.
TOOLS : No special tools required
SUPPLIES: None
PERSONNEL: One
1.
Put puller plate (1) on shaft (2) with bearing (3) as shown. Close puller
plate until inner race (4) of bearing (3) rests on puller plate but plate
does not touch shaft (2).
2.
Tighten two nuts (5) to keep puller plate (1) from opening.
3. Put puller wrench (6) on push-puller (7) as shown. Screw in and
tighten two legs (8) into puller plate (1).
4.
Pull bearing (3) off shaft (2).
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version