|
|
TM 9-2320-209-34-2-1
Section III. DIFFERENTIAL CARRIER ASSEMBLY
TOOLS: Mechanical puller kit, pn 4231596
Mechanical puller kit, pn 8708724
Handle, pn 7083241
Puller, pn 8366689 (2)
Bearing cup replacer, pn 7083252
Oil seal replacer, pn 7083256
Gear replacer, pn 7083257
Oil seal remover, pn 7083250
Bearing remover, pn 7083251
Bearing sleeve remover/replacer, pn 7083246
Hook spanner wrench, pn 7083260
Oil seal remover, pn 7083249
Screw, pn 7083216
SUPPLIES: Differential parts kit
Gasket and shim set
Bevel gear set
Cleaning compound, MIL-C-1109
Oil, MIL-L-17672
Red lead pigment, TT-P-86
Prussian blue, MIL-P-30501
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Fine lapping stone
Safety wire, MS-20995
Gear lubricating oil, GO 80/90, MIL-L-2105
PERSONNEL: TWO
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
a. Preliminary Procedures.
(1) Front axle differential.
(a) Jack up and support truck chassis. Put safety trestles under frame
rails behind front axle housing. Refer to Jacking and Supporting Truck Chassis,
TM 9-2320-209-20.
(b) Drain differential. Refer to LO 9-2320-209-12/1.
(c) Remove propeller shaft. Refer to Propeller Shaft and Universal
Joint Removal and Replacement, TM 9-2320-209-20.
(d) Remove front wheels. Refer to TM 9-2320-209-10.
(e) Remove drag link. Refer to TM 9-2320-209-20.
(f) Remove brake hydraulic lines. Refer to TM 9-2320-209-20.
(g) Remove front axle assembly. Refer to para 10-3.
(h) Place axle on axle stand.
(i) Remove axle shafts. Refer to TM 9-2320-209-20.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |