 |
|||
|
|
|||
|
Page Title:
FLOODLIGHT HARNESS REMOVAL AND REPLACEMENT (TRUCK M756A2). |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-1
NOTE
Refer to removal and replacement procedures given
in TM 9-2320-209-20, if needed, to work on con
nectors and electrical leads covered in this task.
TOOLS : No special tools required
SUPPLIES: 8 gauge wire, 6 feet
PERSONNEL: One
EQUIPMENT CONDITION : Truck parked, engine off, handbrake set.
a. Preliminary Procedure. Remove cab protector. Refer to TM 9-2320-209-20.
b. Removal.
NOTE
Tag all leads so that they are put back in the right place.
1.
Unplug four connectors (1) from left and right floodlights.
2.
Unplug three connectors (2) from clearance lights.
3.
Take off four grommets (3).
4.
Put four connectors (1) through two holes and into cab protector.
5.
Put three connectors (2) through hole and into cab protector.
6.
Put three connectors (4) through hole and into cab protector.
7.
Hook floodlight harness and pull it out through top right end of cab
protector.
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version