FUEL BURNING PERSONNEL HEATER AIR INLET ADAPTER REPAIR.

TM 9-2320-209-20-3-4

23-6. FUEL BURNING PERSONNEL HEATER AIR INLET ADAPTER REPAIR.

TOOLS: Flat-tip screwdriver

11/32-inch wrench (2)

SUPPLIES: None

PERSONNEL: Two

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedure. Open hood and left side panel. Refer to

TM 9-2320-209-10.

b. Removal.

FRAME 1

Using screwdriver, loosen screw (1) and take looped end of

adapter cable assembly (2) off shaft (3). Pull adapter cable

assembly out of cable clamp (4).

Using screwdriver, loosen duct clamp (5) and turn and take off

diverter duct (6).

Soldier A

Using screwdriver, hold two screws (7) and tell soldier B when

ready.

GO TO FRAME 2