|
|
TM 9-2320-209-20-3-3
M109A3, M185A2, AND M185A3).
NOTE
This task is the same for the right and left rear
van door assemblies. This task is shown for
the right rear van door.
3/8-inch drive socket wrench set
TOOLS:
Flat-tip screwdriver
1/2-inch wrench
1/2-inch socket wrench
Hoist sling
6-inch extension
Hoist equipment, 2-ton capacity
10-foot stepladder
SUPPLIES:
None
PERSONNEL:
One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
Preliminary Procedure. If left rear door is being taken off, remove ladder.
Refer to TM 9-2320-209-10.
Removal.
b.
1.
Working inside truck, using screwdriver, unscrew and take out two screws
(1). Pull door check (2) away from door (3). Open door partway.
GO TO FRAME 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |