|
|
TM
9-2320-209-20-3-3
c. Replacement.
FRAME 1
1.
Take grease and work it in on rollers inside bearing (1). Do this
Soldier A
to four bearings that will be used.
2.
Hold yoke (2) with one hole up and the other down.
Soldier B
Put spider (3) in yoke (2) by first putting one end down into hole
Soldier A
3.
where bearing (4) goes. The other end can now be put in.
Soldier B
Hold spider (3) up into top hole as far as it will go.
4.
5.
Put bearing (1) on end of spider (3). Press bearing into yoke (2).
Soldier A
6.
Put brass punch on bearing (1). Using hammer, drive bearing
into yoke (2).
7.
Using retaining ring pliers, put retaining ring (5) into yoke (2).
Soldier B
8.
Hold spider (3) in bearing (1) and turn yoke (2) over. Lift
spider (3) about halfway out of bearing.
Soldier A 9.
Do steps 5, 6, and 7 again for bearing (4).
2
GO TO FRAME
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |