 |
|||
|
|
|||
|
Page Title:
REAR SPRING SEAT WITH BEARINGS REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-2
FRAME 4
Pack cover (1) with grease. Grease both sides of gasket (2). Put gasket on
1.
cover, lining up screw holes.
2.
Put cover (1) with gasket (2) onto spring seat (3), lining up screw holes.
Using 1/2-inch wrench, screw in and tighten six lockwashers (4) and screws
(5).
Using torque wrench, tighten screws (5) to 16 to 20 pound-feet.
3.
Using rag, clean off any grease that squeezed out.
4.
5.
Jack up cross shaft until spring seat (3) just touches spring (6).
GO TO FRAME 5
17-55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version