|
|
TM 9-2320- 209-20-3-2
BRAKE SYSTEM GROUP MAINTENANCE
Section I. SCOPE
procedures for the handbrake assembly and related parts, service brake, hydraulic
brake system, mechanical brake system, air brake system, compressed air system,
and trailer brake connections for which there are authorized corrective maintenance
tasks at the organizational maintenance level.
maintenance is authorized at the organizational maintenance level are covered in
this chapter.
Section II. HANDBRAKE ASSEMBLY AND RELAYED PARTS
13-3. HANDBRAKE BRAKE DRUM REMOVAL AND REPLACEMENT.
3/4-inch wrench
TOOLS: Pliers
1 7/16-inch wrench
6-inch ruler
1 5/16-inch wrench
Torque wrench, 150 pound-feet
1 1/2-inck socket
capacity
Flat-tip screwdriver
Container
Adapter, 1/2 inch to 3/4 inch
6-inch adjustable wrench
Brass punch
3-inch extension, 3/4-inch drive
Hammer
SUPPLIES: Cotter pin
PERSONNEL: One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set, wheels
chocked.
a. Preliminary Procedure. Remove propeller shaft. Refer to Part 2, para
10-3.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |