 |
|||
|
|
|||
|
Page Title:
UNIVERSAL JOINT (SNAPRING, C-RING, AND BEARING CAP TYPE) REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
f.
Assembly (Bearing Cap Type).
Put four retainers (1) and four gaskets (2) on journals (3).
1.
2.
Screw grease fitting (4) into spider (5) and tighten, using 5/16-inch wrench.
Put spider (5) into flange yoke (6) by tilting spider as necessary.
3.
4.
Using fingers, press two bearing caps (7) over two journals (3) through
holes in yoke (6).
5.
Place assembly on a wood block as shown. Hold spider (5) in place and tap
each bearing cap (7) into yoke (6), using rawhide mallet.
GO TO FRAME 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version