 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER REVERSE SHIFT LINKAGE ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
Make sure FRONT TRANSMISSION shift lever (1) stays in position
Soldier A
1.
R (reverse gear).
2.
Using screwdriver from under truck, try to pry reverse shift rod
Soldier B
lever (1) toward transfer (2). If lever cannot be moved more than
1/16-inch, reverse speed adjustment is complete.
If reverse shift rod lever (1) can be moved more than 1/16-inch,
3.
lengthen shift rod (3) as follows:
a.
Using 3/4-inch wrench, loosen jamnut (4).
b.
Using 7/16-inch wrench on flat section of reverse shift rod
(3), unscrew rod from yoke (5).
c. Using 3/4-inch wrench, tighten jamnut (4) against yoke (5).
Do forward speed adjustment procedure again, para 9- 6b and do
4.
reverse speed adjustment procedure again. When conditions of
step 2 (above) are met, reverse speed adjustment is complete.
NOTE
Follow-on Maintenance Action Required:
1. Do transfer reverse shift linkage check, para 9-5.
2. Lower front wheel to ground and take away jack.
Refer to para 11-4.
3. Take wood blocks away from rear wheels.
END OF TASK
9-50
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version