TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT

TM 9-2320-209-20-3-1

9-4. TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER

TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT.

NOTE

Procedures given are the same for both air

actuated positive lockup transmission transfer

and transmission transfer without air actuated

positive lockup, except where noted.

TOOLS:

3/8-inch wrench

8-inch extension

7/16-inch wrench

Vise

9/16-inch wrench (2)

Ruler

Rolling head prybar

3/4-inch wrench (2)

9/16-inch socket wrench

3/4-inch socket wrench

Small hammer

clamp

Vise grip pliers

Jack

Wood blocks

Retaining ring pliers

SUPPLIES:

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

PERSONNEL: TW O

EQUIPMENT

CONDITION: Truck parked, engine off, handbrake set.

CAUTION

On transmission transfers without air actuated

positive lockup, removal of transmission transfer

or reverse shift linkage requires complete

adjustment of reverse-shift linkage. This is to

make sure that double sprag overrunning clutch

works correctly. Refer to para 9-6.

Preliminary Procedures. Remove cab tunnels. Refer to Part 3, para 18-5.