 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER CONTROLS AND LINKAGE WITH POWER TAKEOFF REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
NOTE
Be very careful not to move shifting lever (1) from the
position set in frame 4.
1.
Pull shifter shaft (2) out to engage low speed gears. Check that detent action
holds shaft in this position.
2.
Check if holes in yoke (3) aline with hole in shifter shaft (2). If holes do not
aline, adjust length of rod (4) by screwing yoke (3) onto rod (4) to shorten
rod length or unscrewing yoke (3) from rod (4) to make rod longer.
When holes in yoke (3) aline with hole in shifter shaft (2), put in shoulder
3.
bolt (5) as shown. Screw on locknut (6) and tighten using 3/4-inch wrenches.
GO TO FRAME 6
9-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version