 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER CONTROLS AND LINKAGE WITH POWER TAKEOFF REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 4
Place rear tunnel (1) over transfer shifting lever (2) and aline tunnel mounting
1.
holes with floor holes.
Set transfer shifting lever (2) down to LOW position to get 1/4-to-1/2-inch
2.
clearance from top of rear tunnel. This distance is measured at point (A) as
shown.
Using ruler, measure distance from top of transfer shifting lever (2) to top of
3.
crossbrace (3) as shown.
Take rear tunnel (1) out of cab.
4.
Using ruler, set transfer shifting lever (2) to same distance from crossbrace
5.
(3) as it was in step 3.
GO TO FRAME 5
9-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version