 |
|||
|
|
|||
|
Page Title:
DIRECTIONAL SIGNAL AND SOLID STATE FLASHER REMOVAL, REPAIR, AND REPLACEMENT. - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
d.
Replacement.
(1) Solid state flasher.
FRAME 1
Soldier A
1.
Working under left fender, put two screws (1) through screw holes
in fender. Hold screws in place.
Soldier B
2.
Put flasher (2) on two screws (1). Put lockwashers (3) on screws
and put wire (4) on rear screw as shown. Screw on two nuts (5)
and using 3/8-inch wrench, hold nuts.
Soldier A
3.
Using screwdriver, tighten two screws (1).
Soldier B
4.
Screw on and tighten connector (6).
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version