 |
|||
|
|
|||
|
Page Title:
GENERATOR-TO-REGULATOR HARNESS REMOVAL, REPAIR, AND REPLACEMENT (TRUCKS WITH ENGINES LDS 427-2, LD 465-1, AND LDT 465-IC). |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
c.
Repair.
1.
Take off all loose outer covering (1).
Clean conduit (2) and take off as much of
covering as you can.
2.
Wrap cable with insulating tape from one end to the other. Be sure to have a
lap joint one half the width of the tape. Tie loose end of tape at the connectors
(3).
3.
Resolder any wires which have been broken or pulled off connector terminal
(4).
4.
Clean corrosion from pin terminal and pin socket connector fittings (5 and 6)
with sandpaper or crocus cloth.
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version