Section VI. SENDING UNIT GAGES AND WARNING BUZZERS

TM 9-2320-209-20-3-1

Section VI.

SENDING UNIT GAGES AND WARNING BUZZERS

WATER TEMPERATURE TRANSMITTER REMOVAL

AND

REPLACEMENT.

15/16-inch wrench

TOOLS:

Sealer compound, type II, MIL-S-45180

SUPPLIES:

PERSONNEL:

One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedures.

(1) Open hood and right side panel. Refer to TM 9-2320-209-10.

(2) Drain cooling system (eight quarts) to drop coolant level below engine

intake manifold. Refer to para 6-10.

(3) Disconnect battery ground cable. Refer to para 7-58.

CAUTION

Make sure ACCESSORY switch is set to OFF

position while doing this procedure to pre-

vent electrical damage.

Removal.

FRAME 1

Take connector (1) off water temperature transmitter (2).

Using 15/16-inch wrench, unscrew water temperature transmitter (2) from

intake manifold (3).

END OF TASK