STARTER SWITCH REMOVAL, REPLACEMENT AND ADJUSTMENT (TRUCKS WITH PEDAL STARTER) - continued

TM 9-2320-209-20-3-1

Adjustment.

FRAME 1

Using 1/2-inch wrench, loosen locknut (1) and screw adjusting bolt (2) all the

way in as shown.

Using C-clamp, compress switch return spring (3) to close starter switch (4)

as shown.

CAUTION

In step 3 do not pull lever any further forward than

shown. This could damage spring inside of starter.

Move lever (5) forward in direction shown, until it is almost vertical.

Move lever (5) back and forth a few times. The lever should move freely with-

out binding.

NOTE

If lever does not move freely, take out starter and tell

direct support maintenance. Refer to para 7-10.

GO TO FRAME 2