ALTERNATOR AND PULLEY REMOVAL AND REPLACEMENT.

TM 9-2320-209-20-3-1

AND

REPLACEMENT.

7-4. ALTERNATOR AND PULLEY REMOVAL

Mechanical puller

TOOLS: Flat-tip screwdriver

Strap wrench

0.005-inch feeler gage

7/16-inch socket wrench

3/4-inch wrench

1/2-inch wrench

Torque wrench, 150

5/8-inch wrench

pound-feet capacity

15/16-inch wrench

Torque wrench, 200

pound-inches capacity

9/16-inch wrench

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

SUPPLIES:

Silicone dielectric compound, MIL-S-8660B

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

Preliminary Procedures.

(1) Disconnect battery ground cable. Refer to para 7-58.

(2) Open hood and right side panel. Refer to TM 9-2320-209-10.

Removal.

FRAME 1

NOTE

Cover mounting screws (1) may be at the rear of cover

Using screwdriver, unscrew and take out two screws and lockwashers (1).

Lift off terminal cover (2).

Using screwdriver, unscrew and take out two screws and lockwashers (3).

4. Take off hold down clamp (4).

GO TO FRAME 2