WATER PUMP REMOVAL AND REPLACEMENT.

TM 9-2320-209-20-3-1

c. Replacement.

WARNING

Dry cleaning solvent is flammable. DO not use near open

flame. Keep a fire extinguisher nearby when working

with solvent. Use only in well-ventilated area. Failure

to do this will result in injury to personnel and damage

to equipment.

NOTE

Before installing water pump, clean pump using solvent.

Make sure that all surfaces contacting gaskets or hose

are smooth and free of dirt.

Place water pump (1) on front of engine block as shown.

Put three bolts with lockwashers (2) through water pump mounting holes and

using 9/16inch wrench, tighten bolts.

Put hose (3) on water pump ( 1). Slide clamp (4) into place. Using screw-

driver, tighten clamp.

Slide hose (5) down from thermostat housing (6) over water pump (1) outlet

as shown.

Put clamps (7) near ends of hose (5) as shown. Using screwdriver, tighten

two screws (8).

GO TO FRAME 2

047015

6-40