 |
|||
|
|
|||
|
Page Title:
FUEL LINES AND FITTINGS REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
(d) Bushing
CAUTION
Fittings are made of soft brass. They can be stripped
very easily if overtightened. Tighten fittings only
enough to stop fuel leaking.
NOTE
Bushing at primary filter on trucks with LD-465
engine is used for this typical procedure.
Using 7/8-inch open end wrench, screw in and tighten bushing (1).
1.
Using 7/8-inch open end wrench, hold bushing (1). Using 10-inch pipe wrench,
2.
screw in and tighten elbow (2).
3.
Using 3/4-inch combination box and open end box wrench, screw on and tighten tube
nut (3).
NOTE
Follow -on Maintenance Action Required:
1.
Start engine. Refer to TM 9-2320-209-10.
2.
Check that fuel lines and fittings have no leaks.
Stop engine. Refer to TM 9-2320-209-10
3.
END OF TASK
4-26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version