OIL FILTER ELEMENT REMOVAL AND REPLACEMENT - continued

TM 9-2320-209-20-3-1

NOTE

Make sure all surfaces to which gaskets mate are clean.

Coat both gaskets with a thin coat of engine oil before

putting them back.

Check oil filter repair kit for one small gasket, one large gasket, and one

filter element.

Put small gasket (1) on center post (2) and slide gasket to top end of center

post .

Put center post (2) through hole at top of filter body ( 3).

Put spring (4) in cup (5) and set cup into recessed hole at top end of filter

element ( 6). Be sure cup is properly seated in filter element.

Put threaded end of center post (2) through assembled spring (4) , cup (5),

and filter element (6) .

Slide filter element (6) up center post (2) into filter body (3) until it seats

against top of filter body. Large gasket (7) will be used when the filter

assembly is put back on engine.

Put in cotter pin (8) and bend open ends.

GO TO FRAME 2