REPLACING ENTIRE CABLE ASSEMBLY (OTHER THAN THE WINCH CORNER CABLE ASSEMBLY) - continued

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0038 00

UNIT MAINTENANCE

Adjust the three turnbuckle bodies (1) until their respective CBC corner begins to rise, remove the support

(2) and measure each corner height from the top edge of the cable channel (3) that runs along the top

edge of the CBC lower section, to the interior roof surface of the CBC upper section. The height of all four

corners should be within +/- 1/8 inch using the winch corner (4) as a reference point. If the corners are not

equal, adjust the three turnbuckle bodies (1) until their respective corner is equal to the winch corner

height to within +/- 1/8 inch. Raise and lower the CBC upper section three to five times through

approximately 75 percent of its travel, checking and adjusting the height at each corner each time as

required to ensure that the height at each corner is to within +/- 1/8 inch.

Once all turnbuckles (1) have been adjusted, new turnbuckle locking clips (2) must be installed in the

turnbuckles (1). Using a pair of needle nose pliers slide the long end (straight portion) (3) of a new

turnbuckle locking clip (2) into the left end (4) of the turnbuckle body (1) positioned closest to the winch

corner. Install the bent end (5) of the turnbuckle locking clip (2) into the center hole (6) of the turnbuckle

body (1). Repeat for the right turnbuckle locking clip (7). Repeat turnbuckle locking clip installation

procedure for each turnbuckle body.

0038 00-19