REPLACING ENTIRE CABLE ASSEMBLY (OTHER THAN THE WINCH CORNER CABLE ASSEMBLY)

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0038 00

UNIT MAINTENANCE

REPLACING ENTIRE CABLE ASSEMBLY (OTHER THAN THE WINCH CORNER CABLE

ASSEMBLY)

The entire cable assembly (other than the winch corner cable assembly) consists of one long cable (1)

that extends from the winch to the corner opposite the personnel door from the winch. Three individual

cables branch from the long cable (1) and extend to each of the three corners (other than the winch

corner). Replacement of the entire cable assembly is detailed below; replacement of any of the individual

cables is detailed in the section entitled "REPLACING INDIVIDUAL CABLE ASSEMBLIES (OTHER

THAN THE WINCH CORNER CABLE ASSEMBLY)"

The procedure that follows applies only to the replacement of a cable assembly other than that located at

the winch corner. To replace the winch corner cable assembly, refer to the section of this work package

entitled "REPLACING WINCH CORNER CABLE ASSEMBLY".

Prepare the CBC for cable replacement as detailed in the previous section entitled "PREPARING THE

CBC FOR CABLE REPLACEMENT".

Once the cables are unwound and completely disconnected from the winch barrel, remove the corner

pulley cover plates (2) located at each corner by removing the two screws (3,4) that secure them in place.

Note that the front screw (4) has a spacer (5) and is secured with a locknut (6).

Lift and remove the left (7) and right (8) hand pulley in each corner and set them aside.

0038 00-11