|
|
TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0038 00
UNIT MAINTENANCE
Check to determine if there is slack in the cable. If slack exists, this will require the adjustment of the three
turnbuckle bodies (1) on the long cable assembly (2). If there is slack, raise the CBC upper section (3)
with the winch (4) and remove the supports (5).
Measure each corner height from the top edge of the interlock extrusion (6) attached to the top edges of
the CBC lower section to the interior roof surface (7) of the CBC upper section. The height of all four
corners should be equal within 1/8 inch using the winch corner (8) as a reference point.
Raise and lower the CBC upper section three to five times sending it through approximately 75 percent of
its travel each time, checking and if required, adjusting its height at each corner each time, in order to
maintain an equal height of all four corners within 1/8 inch. If the dimension varies more than 1/8 inch,
then the turnbuckles (1) need to be adjusted as detailed in the section of this work package entitled
"REPLACING CABLE ASSEMBLIES OTHER THAN THE WINCH CORNER", by first removing the
turnbuckle locking clips, making the turnbuckle body adjustment and reinstalling new turn buckle locking
clips after adjustments have been completed.
Install the winch cover (9) by installing the four screws (10), lockwashers (11), and flat washers (12) that
secure the cover (9).
1
3
7
8
6
5
10
11
12
2
9
4
0038 00-10
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |