Click here to make tpub.com your Home Page

Page Title: PERSONNEL DOOR WEATHER STRIPPING
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0035 00
UNIT MAINTENANCE
PERSONNEL DOOR WEATHER STRIPPING
THIS SECTION COVERS:
Inspect, Replace
INITIAL SETUP:
Personnel Required: One
CBC fully extended and locked position
Maintenance Level - Unit
Materials/Parts
Sandpaper, 100 Grit (WP 0055, Table 1, Item 8)
Tools and Special Tools
Rags, Wiping (WP 0055, Table 1, Item 6)
General Mechanic Tool Kit (WP 0041, Table 2,
Solvent, Methylethylketone (WP 0055, Table 1,
Item 1)
Item 3)
Gloves,Chemical And Oil Protective (WP 0041,
Adhesive, (WP 0055, Table 1, Item 20)
Table 2, Item 6)
Catalyst, (WP 0055, Table 1, Item 21)
Sticks, Mixing (WP 0055, Table 1, Item 14)
GENERAL
This procedure contains information and instructions to keep the CBC safe and in good working order by
inspecting and replacing a defective personnel door weather stripping.
INSPECT
Inspect the personnel door weather stripping (1) to ensure that it is fully attached to the upper and lower
personnel door opening frame members. Make sure that the weather stripping for both the upper (2) and
lower (3) door sections is not torn or otherwise damaged that would prevent the personnel door from
sealing properly and/or not preventing outside debris from entering the CBC.
REPLACE
Remove defective seal (1) and strip old adhesive from bonding surface (4).
WARNING
Methylethylketone is flammable and toxic and shall be used only in a
well-ventilated area away from all sparks or open flame. Gloves and
safety goggles should be worn during use.
Sand using sandpaper only if required to remove material not taken off in preceding step.
Wipe bonding surface (4) with a clean cloth dampened with solvent and immediately wipe solvent from
surface with a clean, dry cloth.
0035 00-1

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business