CARRIER MOUNTING ANGLE

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0034 00

UNIT MAINTENANCE

CARRIER MOUNTING ANGLE

THIS SECTION COVERS:

Inspect, Replace

INITIAL SETUP:

Personnel Required: One

Maintenance Level - Unit

Materials/Parts

Tools and Special Tools

General Mechanic Tool Kit (WP 0041, Table 2,

Item 1)

GENERAL

This procedure contains information and instructions to keep the CBC safe and in good working order by

inspecting and replacing a defective carrier mounting angle.

INSPECT

Inspect the carrier mounting angle (1) to ensure that all securing hardware is in place and that there are

no cracks, bends, or otherwise damaged parts that would prevent the carrier mounting angle from

properly securing the CBC to the mounting plate or the vehicle bed.

Also inspect the condition of the CBC sidewall to ensure that it was not damaged in such a way as to

prevent the proper installation of a new carrier mounting angle. If the sidewall is damaged, it must be

repaired in accordance with the work packages in this manual dealing with sidewall repair.

REPLACE

To remove a damaged carrier mounting angle (1), remove all hex bolts (2), lock washers (3), and flat

washers (4) that are securing the damaged carrier mounting angle.

Remove the damaged carrier mounting angle (1).

Install the new carrier mounting angle by aligning the holes (5) in the angle with the holes (6) on the side

wall (7) of the CBC.

Install hex bolts (2), lock washers (3), and flat washers (4) in all mounting holes.

Tighten securely.

0034 00-1