ROOF ACCESS HANDHOLD

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0027 00

UNIT MAINTENANCE

ROOF ACCESS HANDHOLD

THIS SECTION COVERS:

Inspect, Remove, Replace

INITIAL SETUP:

Personnel Required: One

Maintenance Level - Unit

Materials/Parts

Tools and Special Tools

General Mechanic Tool Kit (WP 0041, Table 2,

Item 1)

GENERAL

This procedure contains information and instructions to keep the CBC safe and in good working order by

inspecting and replacing the roof access handhold.

INSPECT

Inspect the rubber gripping surface of the roof access handhold and ensure that there are no surfaces

that could cut or otherwise injure a user's hand.

REMOVE

To remove the roof access handhold (1) remove the four screws (2), lockwashers (3), and flat washers (4)

that secure the handhold (1) to the roof of the Cargo Bed Cover. Note that there is no hardware installed

in the center hole (5) of the roof access handhold (1).

Remove the defective handhold from the roof of the CBC.

REPLACE

Install a new handhold (1) in the same orientation as the original.

Install screws (2), lockwashers (3), and flat washers (4) in four locations to secure the new handhold to

the roof of the CBC.

0027 00-1