ASSEMBLING THE PERSONNEL DOOR - TM-10-5411-233-13-P0050

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0005 00

OPERATION UNDER USUAL CONDITIONS

ASSEMBLING THE PERSONNEL DOOR

Removing the lower personnel door panel from its stowage location. Before the CBC is retracted,

the lower section of the personnel door panel is separated from the upper personnel door and stowed.

Once the CBC is in its fully extended position, the lower personnel door panel (1) must be installed under

the upper personnel door section.

The lower personnel door panel (1) is stowed just inside the door opening on the inside roof surface (2) of

the CBC.

To remove the lower personnel door panel (1) from its stowage location (3) on the underside of the roof

(2), stand inside the CBC facing the door opening while under the door panel.

WARNING

Be sure to support the lower personnel door panel with a free hand

before removing the three hand knobs with threaded studs that secure

the door panel to its stowage bracket on the underside of the roof.

Removing the hand knobs with threaded studs without supporting the

door panel will permit the assembly to fall freely, causing a possible

injury.

Support the lower personnel door panel (1) with a free hand and remove the three hand knobs with

threaded studs (4) that secure the top edge (5) of the door panel to the left hand "Zee" bracket (6).

Lower the top edge (5) of the door panel until the lower edge (7) of the door panel can be removed from

the right hand "Zee" bracket (8). Lower the door panel from its stowage location and set near the door

opening along with the three hand knobs with threaded studs (4).

0005 00-8