 |
|||
|
|
|||
|
Page Title:
REAR HUB AND DRUM MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0188 00
REAR HUB AND DRUM MAINTENANCE (Contd)
CLEANING AND INSPECTION (Contd)
3.
Inspect inner and outer bearing cups (25) and (24) (TM 9-214). If damaged, replace.
4.
Check rivets (7) and backing plate (6) for looseness. If loose, replace axle (WP 0151 00).
NOTE
Perform steps 5 and 6 only if bearings or bearing cups are to be
replaced.
5.
Remove inner and outer bearing cups (25) and (24) from hub (13) by tapping alternately on outer
edge.
6.
Inspect hub (13) for cracks or breaks. If cracked or broken, replace.
7.
Press new inner and outer bearing cups (25) and (24) into hub (13). Make sure cups (25) and (24)
are seated.
8.
Inspect hub (13) for cracks or breaks. If cracked or broken, replace.
9.
Inspect drum (18) for deep grooves and cracks. If cracked or grooved, replace.
10.
Inspect adapter (1) and deflector (2) for cracks or warps. If cracked or warped, replace.
LUBRICATION
1.
Pack inner and outer bearings (4) and (19) with GAA grease (TM 9-214).
2.
Apply light coat of GAA grease to rubber section of new inner bearing seal (5).
3
13
24
5
2
4
25
1
6
8
7
9
10
11
12
17
16
13
15
14
22
23
19
18
20
21
0188 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version