 |
|||
|
|
|||
|
Page Title:
REAR HUB AND DRUM MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0188 00
REAR HUB AND DRUM MAINTENANCE (Contd)
REMOVAL
1.
Bend back tabs on key washer (22), and remove outer adjusting nut (23), key washer (22), and
inner adjusting nut (21) from spindle (8). Discard key washer (22).
CAUTION
Do not slide seal over threaded end of spindle, or damage to seal
may result.
2.
Remove outer seal (20), cork gasket (14), and outer bearing (19) from spindle (8). Discard cork
gasket (14) and outer seal (20).
CAUTION
Do not slide hub and drum assembly over spindle, or damage to
equipment may result.
3.
Remove hub (13) and drum (18) from spindle (8).
DISASSEMBLY
1.
Remove ten nuts (15), lockwashers (16), and inspection cover (17) from drum (18). Discard
lockwashers (16).
2.
Remove ten screws (3) and deflector (2) from adapter (1). Discard screws (3).
3.
Remove hub (13) from drum (18).
4.
Remove safety wire (9), eight screws (10), lockwashers (11), and adapter (1) from hub (13). Discard
safety wire (9) and lockwashers (11).
5.
Remove six wheel studs (12) from hub (13). Discard studs (12).
6.
Remove inner bearing (4) and seal (5) from spindle (8). Discard seal (5).
CLEANING AND INSPECTION
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above ambient
temperatures, or agitated. Keep container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. Wash
contaminated clothing before reuse. Eye contact may cause irritation,
tearing, or blurring of vision. Use face shield or goggles when eye
contact may occur. In case of eye contact, flush eyes with large
amounts of water for at least 15 minutes or until irritation subsides.
Inhalation may cause irritation to upper respiratory passages. DO
NOT have food or drink in the vicinity. Failure to comply may result
in injury to personnel.
Do not use compressed air to dry bearings. Failure to comply may
result in injury to personnel.
1.
Clean all hub (13) and drum (18) components with Skysol 100, and allow to air dry.
2.
Inspect inner and outer bearings (4) and (19) (TM 9-214). If damaged, replace.
0188 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version