 |
|||
|
|
|||
|
Page Title:
UNIVERSAL JOINT (SNAPRING, C-RING, AND BEARING CAP TYPE) REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 3
Place yoke (1) on wood block as shown.
1.
2.
Center drift pin punch (2) on face of top bearing (3) as shown. Tap drift
pin punch lightly with hammer until bottom bearing (4) is driven out.
Turn yoke (1) over and do steps 1 and 2 again to drive out other bearing.
3.
4.
Tilt spider (5) to one side and lift spider out of yoke (1).
5.
Take four gaskets (6) and four retainers (7) off four journals in spider (5).
Throw away gaskets and retainers.
END OF TASK
10-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version