 |
|||
|
|
|||
|
Page Title:
UNIVERSAL JOINT (SNAPRING, C-RING, AND BEARING CAP TYPE) REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
1.
Place one side of yoke (1) on wood block as shown.
NOTE
Diameter of drift pin punch should be just a little
smaller than diameter of bearing.
2.
Center drift pin punch (2) on face of top bearing (3) as shown. Tape drift
pin punch lightly with hammer until bottom bearing (4) is driven out.
3.
Turn yoke (1) over and repeat steps 1 and 2 to drive out other bearing.
4. Tilt spider (5) to one side and lift spider out of yoke (1).
GO TO FRAME 3
10-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version