ACCELERATOR CONTROLS AND LINKAGES REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT.

TM 9-2320-209-20-3-1

4-29. ACCELERATOR CONTROLS AND LINKAGES REMOVAL, REPAIR,

REPLACEMENT, AND ADJUSTMENT.

l/2-inch open end wrench

TOOLS :

l/2-inch socket wrench

Cross-tip screwdriver (Phillips type)

Long nose pliers

Diagonal pliers

None

SUPPLIES :

PERSONNEL : TWO

Truck parked, engine off, handbrake set.

EQUIPMENT CONDITION :

Open hood and left side panel. Refer to

a. Preliminary Procedure.

TM 9-2320-209-10.

Removal.

Take ends of throttle return spring (1) out of swivel assembly (2) and

throttle return clip (3).

Using phillips screwdriver, loosen screw (4) and slide coupling (5) off hand

throttle control wire (6). Pull wire out of clip (7).

Using pliers, take cotter pin (8) out of straight-headed pin (9). Pull out

straight-headed pin.

GO TO FRAME 2