Section III. ENGINE LUBRICATION SYSTEM

TM 9-2320-209-20-3-1

Section III.

ENGINE LUBRICATION SYSTEM

OIL FILTER ELEMENT REMOVAL AND REPLACEMENT.

NOTE

The following tasks are the same for both oil filters.

Drain pan

7/16-inch open end wrench

TOOLS :

7/8-inch wrench

7/8-inch socket

Torque wrench, 150 pound-feet capacity

6-inch long round nose pliers

Oil filter kit, NSN 2940-00-884-4801

SUPPLIES :

Lubricating oil, ICE, OE/HDO 10, MIL-L-2104

PERSONNEL :

One

Truck parked, engine off, handbrake set.

EQUIPMENT CONDITION :

Preliminary Procedure.

Open hood and left side panel. Refer to

TM 9-2320-209-10.

Removal.

Place drain pan under engine to catch oil from oil fitting drain plug ( 1).

Using 7/16-inch wrench, unscrew and take out drain plug ( 1) and wait

until oil stops draining.

Check drained oil for water, dirt or pieces of metal. If any of these are

found, tell direct support maintenance.

GO TO FRAME 2