|
|
TM 9-2320-386-24-1-2
0381 00
FIRST CLUTCH MAINTENANCE (Contd)
11. Position ring gear (6) on bench with extended teeth facing downward.
12. Beginning with external-tanged clutch plates (1), alternately install six internal-splined clutch
plates (2) and external-tanged clutch plates (1) in transmission (7).
13. Install ring gear (6) with tab facing up.
14. Install external-tanged clutch plate (1), internal-splined clutch plate (5), and backplate (4), wider
side down, in transmission (7) with snapring (3). Ensure gap of snapring (3) is at 12 o'clock position
when viewed from the front of transmission (7).
15. Check first clutch running clearance:
a. Using clutch pack clearance gauge, check the clearance between snapring (3) and backplate (4).
Small end of clutch pack clearance gauge should fit in clearance, large side should not.
b. If clearance is excessive, replace clutch plates (1), (2) and (5). Recheck running clearance. If
running clearance is still insufficient, replace with thinner backplate (4) (refer to table 1, First
Clutch Backplate Thickness).
16. Install planetary gearing (WP 0379 00).
Change 1
0381 00-10
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |