 |
|||
|
|
|||
|
Page Title:
TRANSMISSION MANUAL SELECT SHAFT AND SEAL REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0373 00
TRANSMISSION MANUAL SELECT SHAFT AND SEAL REPLACEMENT (Contd)
REMOVAL
CAUTION
Clean around seal area to prevent entry of dirt. Damage may
occur to transmission if dirt enters.
1.
Remove retainer pin (4) from manual select shaft (5) and transmission (1).
2.
Position shift lever seal remover over manual select shaft (5) and turn shift lever seal remover
clockwise to thread into seal (6). Do not remove seal at this time.
3.
Remove nut (3) from manual select shaft (5).
4.
Tighten screw of shift lever remover and remove seal (6) and shift lever seal remover from
transmission (1). Discard seal (6).
5.
Remove detent lever (2) and manual select shaft (5) from transmission (1).
INSTALLATION
1.
Apply oil-soluble grease to lip of new seal (6).
2.
Using shift lever seal installer, install seal (6) on transmission (1).
3.
Insert manual select shaft (5) through seal (6) on transmission (1) and install detent lever (2) on
manual select shaft (5) with nut (3). Tighten nut (3) 15-20 lb-ft (20-27 Nm).
4.
Install retainer pin (4) on manual select shaft (5) and transmission (1).
5.
Install transmission control valve (WP 0371 00).
Change 1
0373 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version