 |
|||
|
|
|||
|
Page Title:
TRANSMISSION GOVERNOR MAINTENANCE |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0369 00
TRANSMISSION GOVERNOR MAINTENANCE (Contd)
REMOVAL
1.
Remove four screws (3), cover (4), and gasket (2) from transmission (1). Discard gasket (2).
2.
Rotate governor (5) clockwise and remove from transmission (1).
CLEANING AND INSPECTION
WARNING
Volatile mineral spirits burn easily and fumes can explode. Do not
smoke or allow flames nearby when using volatile mineral spirits.
Failure to do so may cause serious injury or death to personnel.
CAUTION
All metallic parts must be clean to permit effective inspection. It is
very important that no dirt or foreign material be allowed to enter
the transmission. Even minute particles can cause the malfunction
of close-fit parts, such as valves.
1.
All metallic parts should be cleaned thoroughly with mineral spirits and dried with a lint-free rag.
2.
Parts (except bearings) should be dried with compressed air. Steam-cleaned parts should be oiled
immediately after drying.
3.
After cleaning, inspect parts to make certain they are entirely clean. Reclean them if necessary.
4.
Inspect governor (5) for scratches, burrs, nicks, and scoring. Replace governor (5) if scratched,
burred, nicked, or scored.
INSTALLATION
1.
Install governor (5) on transmission (1). Rotate governor (5) counterclockwise to seat in
transmission (1).
2.
Install new gasket (2) and cover (4) on transmission (1) with four screws (3).
3.
Remove transmission from holding fixture (WP 0367 00).
0369 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version