 |
|||
|
|
|||
|
Page Title:
MOUNTING TRANSMISSION ON HOLDING FIXTURE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0367 00
MOUNTING TRANSMISSION ON HOLDING FIXTURE (Contd)
.WARNING.
All personnel must stand clear during lifting operations. A
snapped chain, or shifting or swinging load may cause injury to
personnel.
Do not remove lifting device until transmission is stable on
holding fixture. Failure to do so may result in injury to personnel
or damage to equipment.
Torque converter must be supported by retaining straps at all
times to prevent torque converter from falling out, causing injury
to personnel.
REMOVAL
1.
Remove six screws (4), cover (3), and gasket (2) from transmission (1). Discard gasket (2).
2.
Install transmission holding fixture on transmission (1) with six washers (10) and 1 1/4-in. long
screws (9).
3.
Install chains on transmission (1) with two screws (5) and (6) and position chains on lifting device.
4.
Raise transmission (1) and install transmission holding fixture on holding fixture base with pin (7)
and setscrew (8).
5.
Remove lifting device, chain, and two screws (5) and (6) from transmission (1).
INSTALLATION
1.
Install chains on transmission (1) with two screws (5) and (6). Install chains on lifting device. Raise
lifting device to remove slack from chain.
2.
Remove setscrew (8), pin (7), and transmission (1) from holding fixture base and lower trans-
mission (1).
3.
Remove lifting device, chains, and two screws (5) and (6) from transmission (1).
4.
Remove six screws (9), washers (10), and holding fixture from transmission (1).
5.
Install new gasket (2) and cover (3) on transmission (1) with six screws (4). Tighten screws
15-20 lb-ft (20-27 Nm).
0367 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version