STEERING GEAR REPLACEMENT - continued - TM-9-2320-386-24-1-20453

TM 9-2320-386-24-1-2

0349 00

STEERING GEAR REPLACEMENT (Contd)

15.

Install turn signal control (4) on steering column (3) and steering wheel (1) with clamp (2).

16.

Install two clamps (6) and reservoir (11) on steering column (3) with two washers (9), screws (10),

and new locknuts (5).

17.

Install cover (8) with tube (7) on reservoir (11).

18.

Align marks on pitman arm (14) and splined shaft (15) and slide pitman arm (14) on shaft (15)

until screw end of shaft (15) comes through.

Install new lockwasher (13) and nut (12). Tighten nut (12) 180-200 lb-ft (244-271 Nm).

19.

20.

Install drag link (17) on ball of pitman arm (14).

21.

Lubricate drag link (17) (para. 3-131).

22.

Tighten adjusting plug (18) until seated (metal-to-metal), then back off adjusting plug (18) 1/2-turn

and install new cotter pin (16).

23.

Install air compressor (WP 0169 00).

24.

Fill steering gear to proper fluid level (WP 0023 00).

25.

Connect battery ground cable (WP 0121 00).

26.

Start engine (TM 9-2320-386-10) and check vehicle steering for proper operation.

27.

Adjust steering gear (WP 0182 00).

0349 00-8