 |
|||
|
|
|||
|
Page Title:
REAR WHEEL RING ADAPTER MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0347 00
REAR WHEEL RING ADAPTER MAINTENANCE (Contd)
REMOVAL
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
When disconnecting air lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
Remove all plugs prior to installation.
NOTE
Mark position of air manifold for assembly.
1.
Using disk grinder with disk, remove epoxy from inboard side of axle spindle (5), ring adapter (1),
and axle spindle notch (6).
2.
Loosen nut (3) and remove CTIS tubing (4), and straight adapter (2) from ring adapter (1).
3.
Remove ring adapter (1) from axle spindle (5). Use soft hammer if necessary.
0347 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version