|
|
TM 9-2320-386-24-1-2
0344 00
FORWARD-REAR AND REAR-REAR AXLE REPLACEMENT (Contd)
WARNING
Axle is heavy. Axle assembly with differential installed is not
balanced and may flip forward or backward if not properly
secured. Ensure axle is secured with chains and personnel are
clear before raising axle. Failure to do so may result in injury
to personnel.
NOTE
Assistant will help with step 5.
5.
Place differential housing (8) on first hydraulic jack and install chains around differential
housing (8) and back to hydraulic jack to support axle (7). Place second hydraulic jack under right
axle housing, outboard of axle (7).
6.
Position two axle spring seats (12) over ends of spring (19), first under differential (8), and using
two hydraulic jacks place axle (7) under vehicle.
7.
Raise hydraulic jacks until axle spring seats (12) touch axle (7) and align holes in axle spring
seats (12) with guide pins (14) on axle (7).
8.
Install two seats (13) in axle spring seats (12).
9.
Align two brackets (15) with axle spring seats (12) and install on axle (7) with two brackets (1),
eight screws (2), new lockwashers (17), and nuts (16). Tighten nuts (16) 200-275 lb-ft (271-373 N.m).
NOTE
Step 10 applies to left side only.
10.
Align upper torque rod (3) and bracket (6) with plate (11) and guide pin (14), and install on axle (7)
and guide pins (14) with four screws (4), two brackets (5), four new lockwashers (10), and nuts (9).
Tighten nuts (9) 200-275 lb-ft (271-373 N.m).
11.
Raise vehicle enough to move two jack stands from under tandem axle spring seats (18) to
under axle (7).
12.
Place jack stands under axle (7) and lower vehicle onto jack stands.
13.
Install four grease fittings (20) on tandem axle spring seats (18).
0344 00-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |