TRANSMISSION (IN-VEHICLE) REPLACEMENT - continued

TM 9-2320-386-24-1-2

0335 00

TRANSMISSION (IN-VEHICLE) REPLACEMENT (Contd)

INSTALLATION

WARNING

Keep rear of transmission tilted slightly downward to prevent

converter from separating from transmission and causing injury

to personnel or damage to equipment.

NOTE

Check that converter has not moved forward before and after installing

retaining brackets. Measure distance from flat on converter to lip on

transmission housing. Distance cannot be more than 1.5 in. (38 mm).

Install two retaining brackets (4), one at 4 o'clock position and one at 8 o'clock position, on

transmission (1) and converter (7) with four washers (3) and (5) and screws (2) and (6).

NOTE

Assistant will help with steps 2 through 15.

Position transmission (1) under vehicle.

Install transmission lifting fixture on transmission (1) with two screws (9) and screw (8), and

connect sling in number two front hole and rear hole of transmission lifting fixture. Install sling to

lifting device.

Adjust sling to lift transmision (1), with front end of transmission tilted downward.

WARNING

All personnel must be clear from under transmission during

lifting, moving, and lowering operations. A snapped cable strap,

chain, or shifting load may cause injury to personnel.

Lift up transmission (1) using transmission lifting fixture, sling, and lifting device into position.

WARNING

No personnel shall be under transmission until transmission jack

has been installed. Failure to do so may cause injury to personnel.

a. Adjust sling to lift up rear of transmission (1) first, and lift up rear of transmission (1) between

flywheel housing (12) and rear braces (10) and (11).

WARNING

Do not place fingers or hands between transmission and flywheel

housing or between rear braces at rear of transmission when

moving transmission forward or lowering transmission. Doing so

may cause injury to personnel.

b. Adjust sling and move rear of transmission (1) slightly right to clear brace (10) as front of

transmission (1) is moved slightly left to clear converter (7) from flywheel housing (12) and lift

transmission (1).

c. Move transmission (1) rearward and adjust sling to align transmission (1) with flywheel

housing (12).

1.5-in. (38mm)

TRANSMISSION

HOUSING

CONVERTER

Change 1

0335 00-12