 |
|||
|
|
|||
|
Page Title:
REAR WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0332 00
REAR WIRING HARNESS REPLACEMENT (Contd)
24.
Remove two locknuts (6), screws (1), and clamps (7) from crossmember (2). Discard locknuts (6).
25.
Disconnect rear wiring harness plug (4) from front wiring harness receptacle (3).
CAUTION
Prior to removal of wiring harness, ensure all clamps have been
removed and disconnections have been performed. Failure to do so
may result in damage to equipment.
Use care when removing wiring harness. Pulling a snagged or
attached wiring harness from the vehicle may result in damage to
equipment.
26.
Remove wiring harness (5) from vehicle.
INSTALLATION
NOTE
If new wiring harness is to be installed, transfer tags installed at
removal from old harness to new harness.
If wiring harness requires repair, refer to WP 0125 00.
As rear wiring harness is installed, position clamps on their
tagged locations, then perform installation as specified for each
location.
Wiring harnesses are engineered for each vehicle configuration.
Adjust wiring harness to remove slack, or allow slack as required
for proper installation.
1.
Position rear wiring harness (5) in vehicle.
2.
Connect rear wiring harness plug (4) to front wiring harness receptacle (3).
3.
Position two clamps (7) on wiring harness (5) and install clamps (7) on crossmember (2) with two
screws (1) and new locknuts (6).
4.
Route wiring harness (5) through grommet (17) and frame rail (18).
5.
Install new lockwasher (15) and ground (GND) lead (13) on fuel tank mounting bracket (19) with
screw (14) and new locknut (8).
6.
Connect harness lead 28 (20) to fuel level sending unit (16).
7.
Install new lockwasher (12) and ground (GND) lead (11) on fuel level sending unit (16) with
washer (10) and screw (9).
0332 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version