REAR WIRING HARNESS REPLACEMENT - continued

TM 9-2320-386-24-1-2

0332 00

REAR WIRING HARNESS REPLACEMENT (Contd)

NOTE

For additional wiring harness replacement information, refer to

Electrical System Wiring Diagram, WP 0386 00.

REMOVAL

NOTE

Tag all leads and clamps for installation.

Upon disconnection, route wires back to closest clamp.

Chafe guard will be reused unless damaged.

Remove plastic chafe guard (6) from wiring harness (7).

Disconnect harness leads 21, 22-461, 23, and 24 (12) on left side and 21, 22-460, 23, and 24 (12) on

right side from taillight leads 21, 22-461, 23, and 24 (13) on left side and 21, 22-460, 23, and 24 (13)

on right side.

Remove locknut (1), clamp (3), and screw (4) from each mounting bracket (2). Discard locknuts (1).

Remove two locknuts (9), clamps (8), and screws (5) from cargo bed bracket (10). Discard locknuts (9).

Remove locknut (37), clamp (36), and screw (35) from frame rail (14). Discard locknut (37).

Remove locknut (38), screw (41), ground (GND) lead (39), and lockwasher (40) from frame rail (14).

Discard locknut (38) and lockwasher (40).

Disconnect leads 380A and 21 (23) from taillight harness leads 380A and 21 (28).

Remove locknut (20), ground (GND) leads (17) and (18), lockwasher (19), screw (15), and

lockwasher (16) from rear cargo bed bracket (10). Discard locknut (20) and lockwashers (16) and (19).

Remove four locknuts (22), two screws (30) and (31), lockwashers (29) and (32), clamp (21),

waterproof cover (33), and trailer receptacle (34) from rear cargo bed bracket (10). Discard

locknuts (22) and lockwashers (29) and (32).

10.

Route trailer receptacle (34) back through cargo bed bracket (10).

11.

Remove locknut (24), screw (26), and clamps (25) and (27) from frame rail (14). Discard

locknut (24).

NOTE

Remove grommets only if damaged.

12.

Remove wiring harness (7) from two grommets (11) on frame rails (14).

0332 00-2