STE/ICE-R WIRING HARNESS REPLACEMENT - continued

TM 9-2320-386-24-1-2

0331 00

STE/ICE-R WIRING HARNESS REPLACEMENT (Contd)

NOTE

Vehicles may come equipped with a Leece-Neville or Prestolite

alternator. The STE/ICE-R wiring harness leads are connected to

negative and positive posts on either alternator.

17.

Install STE/ICE-R harness lead 770-N (12) and positive lead 2 (11) on stud (13) with new

lockwasher (10) and nut (9).

18.

Install STE/ICE-R harness lead 770-P (15) and ground (GND) lead (4) on alternator (14) with new

lockwasher (6) and screw (5). Tighten screw (5) 45-55 lb-in. (5-1-6.2 Nm).

NOTE

Perform steps 19 through 21 for Prestolite alternators only.

19.

Install plate (1) on alternator (14) with two new lockwashers (2) and screws (3). Tighten screws (3)

30-35 lb-in. (3.4-3.9 Nm).

20.

Pack cover plate (8) with sealing compound.

21.

Install cover plate (8) on alternator (14) with two new assembled-washer screws (7).

NOTE

Perform steps 22 and 23 for Leece-Neville alternators only.

22.

Pack cover plate (8) with sealing compound.

23.

Install cover plate (8) on alternator (14) with two new lockwashers (18) and screws (7).

24.

Connect STE/ICE-R plug lead 770-O (17) to Y-connector (16).

25.

Install STE/ICE-R terminal lead 770-T (22) on post (23) with new lockwasher (21) and nut (20).

26.

Install STE/ICE-R terminal lead 770-M (26) on post (27) with new lockwasher (25) and nut (24).

27.

Install STE/ICE-R terminal lead 770-S (30) on post (31) on starter solenoid (19) with new lockwasher (29)

and nut (28).

PRESTOLITE

LEECE-NEVILLE

0331 00-12