 |
|||
|
|
|||
|
Page Title:
STE/ICE-R WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0331 00
STE/ICE-R WIRING HARNESS REPLACEMENT (Contd)
REMOVAL
NOTE
Tag all leads for installation.
For additional wiring harness replacement information, refer to
Electrical System Wiring Diagram, WP 0386 00.
1.
Remove screw (6), lockwasher (5), terminal leads 770-Y (3), 770-W and 770-F (4), and washer (2)
from battery cable negative (-) side of STE/ICE-R shunt (24). Discard lockwasher (5).
2.
Remove screw (7), lockwasher (5), terminal lead 770-X (8), and washer (2) from positive (+) side of
shunt (24). Discard lockwasher (5).
3.
Remove two locknuts (22), screws (15), clamps (16), and STE/ICE-R wiring harness (14) from rear of
battery box (23). Discard locknuts (22).
4.
Remove nut (18), positive battery cable (17), screw (21), slave receptacle cable (1), and STE/ICE-R
terminal lead with wires 770-E and 770-V (20) from positive (+) battery post clamp (19).
5.
Remove locknut (11), screw (13), clamp (12) with STE/ICE-R wiring harness (14), and slave
receptacle cable (1) from frame rail (9), then remove STE/ICE-R wiring harness (14) from clamp (12).
Discard locknut (11).
6.
Remove grommet (10) and route STE/ICE-R wiring harness (14) out from grommet (10) and frame
rail (9).
0331 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version